6.2　Cutting

Ⅰ　Dominant Items

6.2.1　In the cut surface or shear surface of steel material，there shan't be any crack，slag inclusion，stratification，or wane more than 1mm.

Quantity for inspection:one hundred percent；

Inspection method:examine with eyes or hand lens or dial gauge；and when the inspection result is in doubt，detect via permeation flaw detection or magnetic particle inspection or ultrasonic flaw detection.if in doubt.

Ⅱ　General Items

6.2.2　The allowable variations of cutting shall be in conformity with the requirements listed in the Table 6.2.2.

Quantity for inspection:inspect randomly 10% of the total of cut surfaces，but not less than 10；Inspection method:examine with steel rulers or clearance gauges.

Table 6.2.2　Allowable variations for cutting（mm）

Note:t is the thickness of cutting face；d is the diameter of round steel.